Brake Fluid Level Sensor Check; Disc Brake Pad Check And Replacement - Mitsubishi Electric Lancer Evolution-VII Workshop Manual

Front
14Z0017
Front
Front
3
2
1
4
1
3
BASIC BRAKE SYSTEM -

BRAKE FLUID LEVEL SENSOR CHECK

The brake fluid level sensor is in good condition if there is
no continuity when the float surface is above "MIN" and if
there is continuity when the float surface is below "MIN".

DISC BRAKE PAD CHECK AND REPLACEMENT

<Except for Brembo disc brake>
NOTE
The wear indicator contacts the brake disc when the brake
pad thickness reaches approximately 2 mm and emit a
squealing sound to warn the driver.
1. Check the brake pad thickness through the caliper body
Rear
2. When the thickness is less than the limit, always replace
3. Remove the pin bolt. Pivot the caliper assembly and hold
Rear
4. Remove the following parts from the caliper support.
Rear
3
2
4
5. In order to measure the brake drag force after pad
6. Install the pads and caliper assembly, and then check
3
On-vehicle Service
check port.
Standard value: 10.0 mm
Limit: 2.0 mm
the pads at an axle set.
it with wires.
Caution
Do not wipe off the special grease that is on the pin
or allow it to contaminate the pin.
1. Pad and wear indicator assembly
2. Pad assembly
3. Clip
4. Outer shim
installation, measure the rotary-sliding resistance of the
hub with the pads removed. (Refer to P.35A-21.)
the brake drag force. (Refer to P.35A-21.)
35A-11