Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 1321

11A-20
Engine Front
Exhaust
camshaft
Approximately 3_
Dowel Pin
Intake Side
ENGINE -
Camshaft and Camshaft Oil Seal
REMOVAL SERVICE POINTS
AA" RADIATOR UPPER HOSE DISCONNECTION
Indicate the mating marks on the radiator upper hose and
the hose clamp for release.
AB" CAMSHAFT SPROCKET REMOVAL
Hold the hexagon part of the camshaft with a wrench and
loosen the mounting bolt, then remove the camshaft sprocket.
INSTALLATION SERVICE POINTS
"AA LASH ADJUSTER INSTALLATION
Caution
When the lash adjuster is reused, always install it after
cleaning and inspecting.
(Refer to GROUP 11B - Rocker Arms and Camshaft.)
"BA EXHAUST CAMSHAFT/INTAKE CAMSHAFT
1. Remove sealant remained on the cylinder head.
2. Apply engine oil to the cam and the journal of the camshaft.
Slit
3. Install the camshaft to the cylinder head.
"CA CAMSHAFT BEARING CAP NO.4/CAMSHAFT
1. Set the dowel pin of the camshaft to the position as shown
Exhaust Side
INSTALLATION
Caution
Do not install wrong camshaft at the side of intake
or exhaust.
The exhaust camshaft has a slit at the rear surface.
BEARING CAP NO.3/CAMSHAFT BEARING CAP
NO.5/CAMSHAFT BEARING CAP NO.2/
CAMSHAFT BEARING CAP REAR/CAMSHAFT
BEARING CAP FRONT INSTALLATION
in the illustration.