Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 1023

21A-6
Removal steps
D Column cover, under cover, lower
frame (Refer to GROUP 52A.)
1. Connector connection
2. Clutch pedal position switch
3. Clutch pedal position switch sub-har-
ness
4. Clip
5. Stopper
6. Snap pin
No continuity
CLUTCH -
Clutch Pedal
INSPECTION
CLUTCH PEDAL POSITION SWITCH CONTINUITY
CHECK
1. Connect the circuit tester (Ω range) to the connector of
clutch pedal position switch.
Continuity
2. When the shaft is pushed more than the dimension as
shown in the illustration if there is not continuity, and
removing if there is continuity, the switch is good condition.
2.5 1 mm
7. Clevis pin
8. Clutch master cylinder mounting nut
9. Master cylinder member mounting bolt
10. Pedal pad
11. Pedal stopper
12. Clutch pedal assembly
13. Turn over spring
14. Bushing