Troubleshooting; On-Vehicle Service; Door Adjustment - Mitsubishi Electric Lancer Evolution-VII Workshop Manual

42-20
Tool
A
B
C
D

TROUBLESHOOTING

DIAGNOSIS FUNCTION
The power window and central door locking is controlled by the Smart Wiring System (SWS). For
troubleshooting, refer to GROUP 54B - Troubleshooting.
MB990900 or
MB991164
BODY - BODY -
Number Name
MB991223 Harness set
A: MB991219 A: Test harness
B: MB991220 B: LED harness
C: MB991221 C: LED harness
adapter
D: MB991222
D: Probe

ON-VEHICLE SERVICE

DOOR ADJUSTMENT

1. If the gap between the door and body is inconsistent,
paste protection tape at the fender around the hinge
attached portion and at the door edge, use the special
tool to loosen the bolt fixing the door hinge at the body
side, and move the door to adjust so that the gap around
the door becomes consistent.
2. If steps exist between the door and body, use the special
tool to loosen the bolt fixing the door hinge at the door
side, and move the door and adjust the alignment of
the door surface.
Caution
Do not apply torque above 98 NSm for the special
tool (MB991164).
Doors Doors
Use
Terminal voltage measurement
A: Connector pin contact pressure check
B: Power circuit check
C: Power circuit check
D: Commercial tester connection