Test Equipment; Troubleshooting - Mitsubishi Electric Lancer Evolution-VII Workshop Manual

52B-6
SRS -
Tool

TEST EQUIPMENT

Tool

TROUBLESHOOTING

STANDARD FLOW OF DIAGNOSTIC TROUBLESHOOTING
Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points.
DIAGNOSIS FUNCTION
DIAGNOSIS CODES CHECK
Connect the MUT-II to the diagnosis connector (16-pin) under the instrument under cover, then check
diagnosis codes.
(Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points.)
ERASING DIAGNOSIS CODE
Connect the MUT-II to the diagnosis connector and erase the diagnosis code.
Caution
Turn off the ignition switch before connecting or disconnecting the MUT-II.
SRS warning lamp
Special Tools/Test Equipment/Troubleshooting
Number Name
MB686560 SRS air bag
adapter harness
MR203491or SRS air bag
MB628919 adapter harness
Name
Digital multi-meter
SRS WARNING LAMP CHECK
1. Check that the SRS warning lamp comes on when the
ignition switch is turned ON.
2. Check that the SRS warning lamp illuminates for about
7 seconds and then goes out.
3. If this is not the cause, check the diagnosis codes.
Use
Deploying front passenger's air bag module
inside or outside vehicle
Deploying driver's air bag module inside
vehicle <RS>
Use
Checking SRS electrical circuitry
Use multi-meter for which the maximum test
current is 2 mA or less at minimum range of
resistance measurement