Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 414

HEATER, AIR CONDITIONER AND VENTILATION
Hole A
L-shaped
hexagon
wrench
AB"DRIVE BELT REMOVAL
Due to the adoption of the Serpentine drive system with the
automatic tensioner, the following operation is required for
removing the drive belt:
1. Insert the 12.7sq. spinner handle into the tool hole of
the automatic tensioner and rotate it counterclockwise
until the automatic tensioner reaches to the stopper.
2. Align hole A with hole B for fixing by inserting the
L - shaped hexagon wrench, then remove the drive
Hole B
belt.
Caution
When the drive belt is reused, use a chalk to indicate
an arrow of rotation direction on the back of the belt
so that it can be re - assembled in the same direction
as before.
AC" COMPRESSOR REMOVAL
Take care not to spill any compressor oil when removing
the compressor.
INSTALLATION SERVICE POINTS
"AA COMPRESSOR INSTALLATION
When installing a new compressor, first adjust the oil level
as follows.
1. Measure the oil in the compressor you removed.
(X cm
2. Drain the amount of oil calculated by the following formula
from the new compressor. Now install the compressor.
130 cm
NOTE
(1) 130 cm
(2) Y cm
INSPECTION
Compressor Magnetic Clutch Operation Check
Connect the compressor connector terminal to the battery
positive (+) terminal and ground the battery's negative ( - )
terminal to the compressor unit. At that time, the magnetic
clutch should make a definite operating sound.
-
Compressor
)
3
3
– X cm = Y cm
3
indicates the amount of oil sealed in the
3
new compressor at the factory.
indicates the amount of oil in the refrigerant
3
line, compressor, and cooling unit.
55-37
3