13A-144
DISASSEMBLY AND REASSEMBLY
2.0 ± 0.5 N•m
1
Removal steps
"AA 1. Throttle position sensor
2. Idle speed control servo
3. O-ring
(1)
(2)
MPI -
4
5
INSTALLATION SERVICE POINT
"AA THROTTLE POSITION SENSOR INSTALLATION
1. Set the throttle position sensor on the throttle body as
2. Turn and set the throttle position sensor to the position
Throttle Body
6
3
4. Fixed SAS
5. O-ring
6. Throttle body
shown in illustration (1).
shown in illustration (2), connect a circuit tester across
terminal No. 2 (Throttle position sensor output) and
terminal No. 4 (earth), and measure the output voltage.
Tighten the throttle position sensor with a screw at the
position where the output voltage is at the standard value.
Standard value: 0.535 - 0.735 V
2