Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 991

22B-26
MANUAL TRANSMISSION OVERHAUL -
MD998801
Thrust
plate
MD998812
MD998813
MD998825
MD998801
Snap
ring
"IA 5TH SPEED GEAR INSTALLATION
MD998812
Using the special tool, install the 5th speed gear onto the
MD998813 input shaft.
Caution
MD998825
(1) Press in so that the synchronizer ring does not bite
(2) After assembling, confirm that the 4th speed gear
"JA THRUST PLATE INSTALLATION
Select and install the thrust plate onto the input shaft so
Stamped
that the input shaft 5th speed gear clearance is at the standard
surface
value.
Standard value: 0.01 mm tight to 0.09 mm loose
Caution
Assemble the side with the identification stamp facing the
thrust plate stopper side.
"KA THRUST PLATE STOPPER INSTALLATION
Press the special tool by hand, and accurately fit the thrust
plate stopper onto the input shaft so that it is not inclined.
"LA BALL BEARING INSTALLATION
MD998812
Using the special tool, install the ball bearing onto the input
shaft.
MD998819
"MASNAP RING INSTALLATION
Select and install the snap ring onto the input shaft so that
the input shaft rear bearing clearance is at the standard value.
Standard value: 0.01 mm tight to 0.12 mm loose
in.
rotates smoothly.
Input Shaft