Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 1322

Bearing cap No.
Engine Front
Identification of
intake side and
exhaust side
Engine Front
Front marking
Engine Front
MD998713
ENGINE -
Camshaft and Camshaft Oil Seal
2. Since the shape of camshaft bearing caps No.2 - 5 is
3. Apply sealant to the positions (6 areas) of the upper side
4. Position the camshaft bearing cap rear in the direction as
5. Check the identification marks on the camshaft bearing
6. Tighten the bearing cap mounting bolt increasing the
7. Ensure that the rocker arm is installed properly.
"DA CAMSHAFT OIL SEAL INSTALLATION
1. Apply engine oil on the circumference of oil seal lip.
2. Use the special tool as shown in the illustration to pressfit
"EA CAMSHAFT SPROCKET INSTALLATION
Hold the hexagon part of the camshaft with a wrench and
tighten the mounting bolt to the specified torque in the same
way as that for removal.
Tightening Torque: 89 ± 9 N·m
identical, check the identification marks so that the bearing
cap No., intake side, or exhaust side cannot be mistaken
to install to the direction as shown in the illustration.
Identification mark (engraved on the front and bearing
caps No.2 - 5)
I: Intake side
E: Exhaust side
of the cylinder head as shown in the illustration.
Specified sealant:
MITSUBISHI GENUINE PART MD970389 or
equivalent
shown in the illustration for installation.
cap front so that intake side and exhaust side cannot
be mistaken in the same way as that of bearing caps
No.2 - 5.
pressure in 2 to 3 times and finally tighten to the specified
torque.
Tightening Torque: 20 ± 1 N·m
NOTE
Remove an excess of sealant completely.
the oil seal.
11A-21