Hydraulic Unit - Mitsubishi Electric Lancer Evolution-VII Workshop Manual

27B-62
REAR AXLE REAR AXLE
Pipe

Hydraulic unit

hose assembly
Differential support arm
Nipple
Hook
Rear floor side member
- Hydraulic Unit <Vehicles with ACD+AYC> - Hydraulic Unit <Vehicles with ACD+AYC>
REMOVAL SERVICE POINTS
Hose
AA" HYDRAULIC UNIT HOSE ASSEMBLY REMOVAL
1. Disconnect the hydraulic unit side pipe and hose.
2. Put down the differential support arm, remove the
HYDRAULIC UNIT DISPOSAL
Should the hydraulic unit be discarded, drill a hole in the
accumulator at the illustrated position beforehand in order
to release the inside gas.
Caution
(1) The hydraulic unit has its accumulator filled with a high
(2) When drilling a hole in the accumulator, be sure to
INSTALLATION SERVICE POINTS
"AA RESERVOIR HOSE ASSEMBLY INSTALLATION
Insert the reservoir hose assembly to the positioning spool.
Positioning
spool
Reservoir hose
assembly
"CA HYDRAULIC UNIT ASSEMBLY INSTALLATION
Hook the hydraulic unit assembly hook to the rear floor side
member and tighten the hydraulic unit assembly mounting
bolt.
hydraulic unit hose assembly.
pressure gas. Never throw it into a fire. Also, never
attempt to disassemble, press, weld or melt it.
wear safety goggles since drill chips may blow out
together with the gas.