Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 773

35B-26
ABS <4WD> -
ABS-ECU terminal No.
6 - 7
8 - 9
22 - 31
29 - 30
12 - Body earth
34 - Body earth
Lock lever
Troubleshooting/On-vehicle Service
RESISTANCE AND CONTINUITY BETWEEN
HARNESS-SIDE CONNECTOR TERMINALS
1. Turn the ignition key to the "LOCK" (OFF) position.
2. Disconnect the ABS-ECU connector.
3. Check the resistance and continuity between the terminals
indicated in the table below.
4. The terminal layout is shown in the illustration.
Signal
Wheel speed sensor (rear left)
Wheel speed sensor (rear right)
Wheel speed sensor (front left)
Wheel speed sensor (front right)
Earth
Earth
ON-VEHICLE SERVICE
WHEEL SPEED SENSOR OUTPUT VOLTAGE
CHECK
1. Lift up the vehicle and release the parking brake.
2. Move the lock lever of the ABS-ECU connector as shown
in the illustration, and then disconnect the ABS-ECU
connector.
3. Push up and unlock the hooks of the ABS-ECU connector
shown in the illustration, then remove the connector cover.
Normal condition
1.24 - 1.64 kΩ
Continuity