Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 1031

21B-4
Bush
Release fork
Valve plate spring
Valve plate
CLUTCH OVERHAUL -
REASSEMBLY SERVICE POINTS
"AA BUSH INSTALLATION
Press the bush into the position of the release valve shown
in the illustration.
"BA RELEASE FORK INSTALLATION
Apply grease on the release fork at the position shown in
the illustration.
"CA SEALING CAP INSTALLATION
Press the sealing cap into the position shown in the illustration
2 mm
while taking care so that it is not tilted.
"DA CLUTCH RELEASE CYLINDER INSTALLATION
Fill grease in the release fork to the position shown in the
illustration.
"EA VALVE PLATE SPRING/VALVE PLATE
Release cylinder
Set the spring's large diameter side to the valve plate side,
and install the valve plate spring and valve plate.
Clutch
Grease
Specified grease:
MITSUBISHI genuine grease Part No.0101011
or equivalent
Grease
Specified grease:
MITSUBISHI genuine grease Part No.0101011
or equivalent
INSTALLATION