Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 1077

16-22
"B" terminal
"M" terminal
Stop ring
Snap ring pliers
ENGINE ELECTRICAL -
DISASSEMBLY SERVICE POINTS
"S" terminal
AA" MAGNETIC SWITCH REMOVAL
Disconnect field coil wire from "M" terminal of magnetic switch.
Field coil
wire
AB" ARMATURE/BALL REMOVAL
Caution
When removing the armature, take care not to lose the
ball (which is used as a bearing) in the armature end.
AC"SNAP RING/STOP RING REMOVAL
Socket
1. Press stop ring off snap ring with a suitable socket.
Pinion gear
Overrunning
clutch
2. Remove snap ring with snap ring pliers and then remove
Snap ring
Pinion gear
Overrunning
clutch
STARTER MOTOR PARTS CLEANING
1. Do not immerse parts in cleaning solvent. Immersing the
2. Do not immerse drive unit in cleaning solvent. Overrunning
3. The drive unit may be cleaned with a brush moistened
Starting System
stop ring and overrunning clutch.
yoke and field coil assembly and/or armature will damage
insulation. Wipe motor assembly with a cloth only.
clutch is pre-lubricated at the factory and solvent will wash
lubrication from clutch
with cleaning solvent and wiped dry with a cloth.