Oil Pan - Mitsubishi Electric Lancer Evolution-VII Workshop Manual

ENGINE -
10 mm
Cylinder Head
Engine Front

OIL PAN

REMOVAL AND INSTALLATION
Pre-removal and Post-installation Operation
Under Cover Removal and Installation (Refer to GROUP 51 - Front Bumper.)
D
Drainage and Refilling of Engine Oil (Refer to GROUP 12 - On-vehicle Service.)
D
Crossmember Bar Removal and Installation (Refer to GROUP 32 - Engine Roll Stopper, Centermember.)
D
Front Exhaust Pipe Removal and Installation (Refer to GROUP 15.)
D
Starter Removal and Installation (Refer to GROUP 16.)
D
Camshaft and Camshaft Oil Seal/Oil Pan
"JA CAMSHAFT END SEAL INSTALLATION
Apply sealant to the positions of the camshaft end seal as
shown in the illustration and install to the cylinder head.
Specified sealant: 3M ATD Part No.8660 or equivalent
10 mm
"KA ROCKER COVER INSTALLATION
1. Apply sealant to the positions of the rocker cover gasket
(6 areas) as shown in the illustration.
Specified sealant:
MITSUBISHI GENUINE PART MD970389 or
equivalent
2. Install the rocker cover to the cylinder head.
11A-23