Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 1015

22B-50
MANUAL TRANSMISSION OVERHAUL -
(5) Install the front output shaft onto the side gear, and install
the snap ring.
(6) After assembling the side gear into the center differential
case, install the spacer onto the side gear.
(7) Match the alignment marks, install the center differential
flange, and temporarily fix the machine screw.
(8) Measure the backlash between the side gear and pinion.
Standard value: 0.025 - 0.150 mm
(9) If the backlash is not within the standard value, select
a spacer, and measure the backlash again.
NOTE
Adjust so that the backlash on both sides is even.
"DA CENTER DIFFERENTIAL DRIVE GEAR
INSTALLATION
(1) Confirm that rust-proofing oil is applied, and then apply
sealant on all of the bolt threads.
Sealant
Specified sealant:
3M STUD Locking No.4170 or equivalent
(2) Tighten with the specified torque following the order shown
in the illustration.
Center Differential