Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 604

Deployment harnesses
Insulation tape
SRS air bag
adapter
harness
MR686560
Deployment
harnesses
Air Bag Module and Seat Belt Pre-tensioner
SRS -
Disposal Procedures
Shorted
6 m long
or more
(6) Disconnect the deployment harnesses as far from
the front passenger's air bag module as possible and
connect the harnesses to the battery removed from
the vehicle.
Caution
1) Before the deployment, see that no one is near
the front passenger's air bag module.
2) The deployment makes the inflator of the front
passenger's air bag very hot. Before handling
the inflator, wait more than 30 minutes for
cooling.
3) If the front passenger's air bag module fails to
deploy although the procedure is respected,
do not go near the module. Contact your local
distributor.
(7) Discard the deployed air bag module as specified
in Deployed Air Bag Module Disposal Procedures.
(Refer to P.52B-75.)
Seat belt pre-tensioner
(1) Remove the seat belt with pre-tensioner from the
vehicle. (Refer to P.52B-61.)
Caution
Once disconnected, both electrodes of the seat
belt pre-tensioner
automatically to prevent accidental deployment
caused by static etc. Still, in consideration of the
accidental deployment, store the air bag module
on flat place with deployment surface facing up.
Also, do not put anything on it.
(2) Connect deployment harness 6 m or longer with the
SRS air bag adapter harness respectively. Insulate
the connection with tape.
Moreover, the ends of the operation harness should
be connected (short-circuited) to each other. Thus,
it prevents the seat belt pre-tensioner from accidental
deployment caused by static and etc.
52B-73
are short-circuited