Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 435

54A-12
CHASSIS ELECTRICAL -
Ignition Switch and Immobilizer System
INSPECTION
IGNITION SWITCH CONTINUITY CHECK
With ignition switch installed on the vehicle, disconnect ignition
switch connector for inspection.
Ignition key g y
Terminal No.
position iti
1
LOCK
ACC
ON
START
KEY REMINDER SWITCH CONTINUITY CHECK
With key reminder switch installed on the vehicle, disconnect
key reminder switch connector for inspection.
Ignition key status g y
Remove
Insert
ENCRYPTED CODE REGISTRATION METHOD
AND RESETTING THE CODE TO THE FACTORY
SETTING
Register the encrypted code in the immobilizer-ECU and then
reset the code to the factory setting after parts have been
replaced.
Replacement part
Ignition key
Immobilizer-ECU
Engine-ECU*
NOTE
*: If the engine-ECU is replaced, the immobilizer-ECU should
be replaced. Each engine-ECU has an individual information
for immobilizer-ECU, and the individual information is
registered in the immobilizer-ECU.
2 4 5
Terminal No.
4 6
Encrypted code
Necessary
Necessary
Necessary
6