Engine Coolant Temperature Gauge Unit Check - Mitsubishi Electric Lancer Evolution-VII Workshop Manual

Main fuel gauge unit
A
B
Sub fuel gauge unit
A
B
Thermometer
11
CHASSIS ELECTRICAL -
FLOAT HEIGHT OF FUEL GAUGE UNIT
When float is moved to contact float arm on stopper,
ensure that Position F (A) and E (B) are within standard
value.
ENGINE COOLANT TEMPERATURE GAUGE
Circuit tester
UNIT CHECK
1. Drain coolant. (Refer to GROUP 14 - On-vehicle Service)
2. Remove water temperature gauge unit.
3. Put water temperature gauge unit into the hot water in
4. After inspection, apply specified sealant at threads of
5. Refill coolant. (Refer to GROUP 14 - On-vehicle Service.)
1 N·m
±
Combination Meter
Standard Value:
Float Position Float Position Main fuel gauge unit Main fuel gauge unit
Position F (A) 33.3 mm
Position E (B) 121.9 mm
specified temperature, and ensure that basic resistance
is within standard value.
Standard value: 70_C 104 ± 13.5 Ω
Reference value:
Temperature
50_C
60_C
80_C
water temperature gauge unit, and tighten to the specified
torque.
Semi-drying sealant: 3M ATD Part No.1215 or
equivalent
54A-21
Sub fuel gauge unit Sub fuel gauge unit
10.7 mm
138.6 mm
Resistance Ω
230
155
73