Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 740

<Front>
MB990998
<Rear>
MB990998
BASIC BRAKE SYSTEM -
INSTALLATION SERVICE POINT
"AA DISC BRAKE ASSEMBLY INSTALLATION
<Except for Brembo disc brake>
1. In order to measure the brake drag force after pad
Bolt
Bolt
2. Install the caliper support to the knuckle, and then
3. Clean the piston and insert it into the cylinder with the
4. Be careful that the piston boot does not become caught,
MB990520
5. Start the engine, and then depress the brake pedal two
6. Turn the brake disc forward 10 times.
7. Use a spring balance to measure the rotary-sliding
8. Calculate the drag force of the disc brake [difference
9. If that drag force exceeds the standard value, disassemble
<Brembo disc brake>
1. Find the drag force of the disc brake. (Refer to P.35A-13.)
2. If that drag force exceeds the standard value, disassemble
Disc Brake
installation, measure the rotary-sliding resistance of the
hub by the following procedure with the pads removed.
(1) Withdraw the drive shaft. (Refer to GROUP 26, 27.)
(2) Attach the special tool to the front hub assembly as
shown in the illustration, and tighten it to the specified
torque.
Tightening torque:
245 ± 29 N·m <Front>, 225 ± 25 N·m <Rear>
(3) Use a spring balance to measure the rotary-sliding
resistance of the hub in the forward direction.
assemble the pad and the clip to the caliper support.
Caution
Do not contaminate the friction surfaces of the pads
and brake discs by any oil or grease.
special tool.
when lowering the caliper assembly and install the guide
pin to the caliper.
or three times strongly. Then stop the engine.
resistance of the hub in the forward direction.
between the values measured at steps 1 and 7].
Standard value:
51 N or less <Front>, 69 N or less <Rear>
the piston assembly. Then check the piston for
contamination or rust, and confirm if the piston or the
piston seal is deteriorated, and if the slide pins slide
smoothly.
Standard value: 69 N or less
the piston assembly. Then check the piston for
contamination or rust, and confirm if the piston or the
piston seal is deteriorated.
35A-21