Code No.61 Stop lamp switch system
Code No.61 is output when the stop lamp switch is ON for more than 15
minutes when the vehicle speed is above 15 km/h.
Check for brake pedal height
(Refer to GROUP 35A – On-vehicle Service.)
NG→Adjust
MUT-II Data List
D No.56 Stop lamp switch
(1) Depress the brake pedal.
OK: ON
(2) Release the brake pedal.
OK: OFF
OK→Intermittent malfunction (Refer to GROUP 00 - Points to
Note for Intermittent Malfunctions)
Check the following connector: C-103
NG→Repair
Check the stop lamp switch.
(Refer to GROUP 35A - Brake Pedal.)
NG→Replace
Measure at stop lamp switch connector C-103.
D Disconnect the connector and measure at the harness
side.
D Voltage between terminal 2 and earth
OK: System voltage
Measure at 4WD-ECU connector C-43.
D Measure the ECU terminal voltage.
D Voltage between terminal 38 and earth
(1) Depress the brake pedal.
OK: System voltage
(2) Release the brake pedal
OK: 1 V or less
Check
the
followingconnectors:
Check the harness between the stop lamp switch and stop
Check the harness between the 4WD-ECU and stop lamp
Check the stop lamp bulb.
OK
MANUAL TRANSMISSION - Troubleshooting <ACD>
OK
NG
OK
OK
OK
NG
OK
Probable cause
D Brake pedal fault
D Stop lamp switch fault
D Harness or connector fault
D 4WD-ECU fault
NG
Check the following connectors: C-103, C-135
NG→Repair
Check the harness between the stop lamp switch and battery.
D Check for open circuit or damage of the power line.
NG→Repair
OK
MUT-
22A-25
OK
OK