Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 664

<FRONT DOOR>
Waterproof film
<REAR DOOR>
Waterproof film
Horizontal line
30_
Front of vehicle
BODY -
Doors
INSTALLATION SERVICE POINTS
"AA WATERPROOF FILM INSTALLATION
Apply the specified adhesive on the waterproof film as shown
in the illustration, and then glue it on the door window glass.
Specified sealant: 3M ATD Part No. 8625 or equivalent
"BA REGULATOR HANDLE/ESCUTCHEON/CLIP
INSTALLATION
1. Install the clip and escutcheon to the regulator handle.
2. Close the front door window glass fully, and then install
the regulator handle as shown in the illustration.
INSPECTION
Power window main switch uses SWS system, for the
power window main switch check, refer to GROUP 54B
- SWS.
POWER WINDOW SUB SWITCH CONTINUITY CHECK
Switch position p
UP
DOWN
Terminal No.
2 3
42-31
6