Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 942

MANUAL TRANSMISSION - Troubleshooting <ACD>
DATA LIST REFERENCE TABLE
Item Check item
no.
01 Wheel speed sensor
<FR>
02 Wheel speed sensor
<FL>
03 Wheel speed sensor
<RR>
04 Wheel speed sensor
<RL>
05 Wheel speed sensor
<FR> (0.2 km/h)
06 Wheel speed sensor
<FL> (0.2 km/h)
07 Wheel speed sensor
<RR> (0.2 km/h)
08 Wheel speed sensor
<RL> (0.2 km/h)
09 Vehicle speed
10 Battery voltage
11 Proportional valve cur-
rent <ACD>
12 Proportional valve cur-
rent <AYC>
13 TPS voltage
14 Longitudinal G sensor
voltage g
15 Lateral G sensor volt-
age g
16 Steering operation
angle g
17 Steering angle velocity g g
18 Pressure sensor
Check condition
Execute actual driving.
Ignition switch: ON
During ACD operation
During AYC operation
Ignition switch: ON
Engine: Stopped Engine: Stopped
Ignition switch: ON
Ignition switch: ON
Ignition switch: ON
y Ignition switch: ON g
During electric pump motor operations
Accelerator pedal: Full
closed
Accelerator pedal: Press
Accelerator pedal: Full
throttle
Vehicle stopped (horizon-
tal) state
Actual driving
Vehicle stopped (horizon-
tal) state
Perform actual driving
Steering wheel: Steer by 90
degrees to the right
Steering wheel: Steer by 90
degrees to the left
Steering wheel: No steering
Steering wheel: Steer
22A-35
Normal conditions
The speed meter dis-
p y play and MUT-II dis-
play match. l t h
System voltage
50 - 1,000 mA
50 - 1,000 mA
535 - 735 mV
Gradually rises from
the above value
4,500 - 5,000 mV
2.4 - 2.6 V
The displayed value
increases and de-
creases mainly around
2.5 V.
2.4 - 2.6 V
The displayed value
increases and de-
creases mainly around
2.5 V.
R90 deg
L90 deg
0 deg/s
The display changes
according to the revolu-
tion speed.
1.0 - 1.6 MPa