Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 1000

MANUAL TRANSMISSION OVERHAUL -
Snap ring
"A"
Gear
Synchronizer
ring
"PA SNAP RING INSTALLATION
Select and install the snap ring onto the output shaft so that
the output shaft rear bearing clearance is at the standard
value.
Standard value: 0.01 mm tight to 0.09 mm loose
INSPECTION
OUTPUT SHAFT
Check the spline for damage and wear.
NEEDLE BEARING
(1) When the needle bearing is assembled with the bearing
sleeve and gear and rotated, the needle bearing must
rotate smoothly without play or abnormal noise.
(2) The holder must not be deformed.
SYNCHRONIZER RING
(1) The clutch gear teeth must not be damaged or broken.
(2) The inner diameter of the cone must not be damaged
or worn, and the screw threads must not be crushed.
(3) Press the synchronizer ring against the gears, and check
the clearance "A". Replace if "A" is less than the limit
value.
Limit value: 0.5 mm
Output Shaft
22B-35