Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 1366

Timing belt side
Crankshaft sprocket B
Degrease
Spacer
Chamfer
Timing
marks
ENGINE OVERHAUL -
3. Apply form-in-place gasket on the rocker cover at the
position shown in the illustration.
Sealant
4. Install the rocker cover onto the cylinder head before
the form-in-place gasket hardens.
"EA CRANKSHAFT SPROCKET B INSTALLATION
Clean the crankshaft sprocket B installation surface before
Crankshaft
degreasing the crankshaft sprocket B.
NOTE
Always degrease the surface to prevent a drop in the frictional
coefficient at the pressing section caused by the adherence
of oil.
"FA SPACER INSTALLATION
Oil seal
1. Apply a slight amount of oil on the outer periphery of
the spacer (oil seal contact section).
2. Insert the spacer from the chamfered side as shown in
the illustration.
Caution
Reversed insertion of the spacer can cause damage
to the oil seal lip.
"GA COUNTER BALANCE SHAFT SPROCKET
1. Fix the counter balance shaft sprocket with the special
tool.
2. Tighten the counter balance shaft sprocket installation
MD998785
bolt at the specified torque 46 ± 3 N•m.
"HA TIMING BELT B INSTALLATION
1. Align the crankshaft sprocket B and counter balance shaft
sprocket timing marks with the timing mark on the oil
Timing
marks
pump case.
2. Attach the timing belt B to the crankshaft sprocket B
and counter balance shaft sprocket.
Do not loosen the belt tension too much at this time.
Timing Belt
Specified sealant:
TM
3M AAD Part No. 8672 or equivalent
INSTALLATION
11B-17