Starting System; General Information - Mitsubishi Electric Lancer Evolution-VII Workshop Manual

STARTING SYSTEM

GENERAL INFORMATION

If the ignition switch is turned to the "START"
position, current flows in the pull-in and holding
coils provided inside magnetic switch, attracting
the plunger. When the plunger is attracted, the
lever connected to the plunger is actuated to
engage the starter clutch.
On the other hand, attracting the plunger will turn
on the magnetic switch, allowing the B terminal
SYSTEM DIAGRAM
STARTER MOTOR SPECIFICATIONS
Items
Type
Rated output kW/V
No. of pinion teeth
SERVICE SPECIFICATIONS
Items
Pinion gap mm
Commutator outer diameter mm
Commutator runout mm
Commutator undercut mm
Brush length mm
ENGINE ELECTRICAL -
Ignition
switch
Battery
Brush
Standard value
0.5 - 2.0
29.4
0.05
0.5
-
Starting System
and M terminal to conduct. Thus, current flows to
engage the starter motor.
When the ignition switch is returned to the "ON"
position after starting the engine, the starter clutch
is disengaged from the ring gear.
An overrunning clutch is provided between the
pinion and the armature shaft, to prevent damage
to the starter.
Plunger
Holding coil
Pull-in coil
Armature
Yoke
Specifications
Reduction drive with planetary gear
1.2/12
8
Lever
Over-running
clutch
Pinion shaft
Limit
-
28.8
0.1
0.2
7.0
16-17