Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 1326

ø4 mm
at the groove
M6 × 8 mm
Gasket
Convex part
ENGINE -
INSTALLATION SERVICE POINTS
"AA OIL PAN INSTALLATION
1. Remove sealant remained on the oil pan and the cylinder
2. Apply sealant on the mounting surface of oil pan without
at the bolt hole
3. Tighten the mounting bolt of oil pan to the specified torque.
"BA DRAIN PLUG GASKET INSTALLATION
Gasket should be replaced with a new one, and install it
in the direction specified in the figure.
Oil Pan Side
"CA OIL RETURN PIPE GASKET INSTALLATION
Gasket should be replaced with a new one, and set the convex
part to the position as shown in the illustration for installation.
NOTE
There is no specific direction indicated for installing the
turbocharger side of the oil return pipe gasket.
INSPECTION
D
D
D
Oil Pan
block.
any gap as indicated in the figure, and install oil pan
on cylinder block.
Specified sealant:
MITSUBISHI GENUINE PART MD970389 or
equivalent
Be careful not to use a wrong bolt when tightening the
bolt as shown in the illustration.
Tightening Torque: 9.0 ± 3.0 N·m
Check oil pan for cracks.
Check oil pan sealant - coated surface for damage and
deformation.
Check oil screen for cracked, clogged or damaged wire
net and pipe.
11A-25