Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 779

35B-32
Lock lever
2
1
ABS <4WD> -
Hydraulic Unit and ABS-ECU
REMOVAL SERVICE POINTS
AA" HARNESS CONNECTOR DISCONNECTION
Move the lock lever of the ABS-ECU connector as shown
in the illustration, and then disconnect the harness connector.
AB" HYDRAULIC UNIT AND ABS-ECU REMOVAL
Caution
1. The hydraulic unit assembly is heavy, and so care
2. The
3. The hydraulic unit assembly must not be dropped
4. The hydraulic unit assembly must not be turned
INSTALLATION SERVICE POINT
3
4
"AA BRAKE PIPE CONNECTION
5
Connect the pipes to the hydraulic unit assembly as shown
in the illustration.
1. From the master cylinder (Secondary)
2. To the front brake (LH)
3. To the rear brake (RH)
6
4. To the rear brake (LH)
5. To the front brake (RH)
6. From the master cylinder (Primary)
should be taken when removing it.
hydraulic unit
disassembled; its nuts and bolts should absolutely
not be loosened.
or otherwise subjected to impact shocks.
upside down or laid on its side.
assembly is not to be