Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 1378

ENGINE OVERHAUL -
Intake manifold stay
1
5
2
Secondary Air System and Intake Manifold
INSTALLATION SERVICE POINTS
"AA INTAKE MANIFOLD STAY INSTALLATION
Check that the intake manifold stay is seated against the
intake manifold and cylinder block boss, and then tighten
at the specified torque 31 ± 3 N•m.
"BA MANIFOLD DIFFERENTIAL PRESSURE (MDP)
Caution
Make sure not to apply impact against the sensor when
installing.
Do not use a sensor that has been dropped.
"CA AIR CONTROL VALVE BRACKET INSTALLATION
1. Temporarily tighten the air control valve bracket and
engine hanger with the bolt for tightening with the intake
manifold.
2. Tighten the bolt 1 shown in the illustration at the specified
torque 23 ± 4 N•m.
3. Tighten the bolt 2 shown in the illustration at the specified
torque 36 ± 6 N•m.
2 3
4. Tighten the bolt 3 shown in the illustration with the engine
hanger at the specified torque 22 ± 4 N•m.
"DA AIR PIPE ASSEMBLY INSTALLATION
3
1. Temporarily tighten air pipe assembly onto the air control
valve.
2. Tighten the bolts 1 and 2 shown in the illustration to
4
the exhaust manifold at the specified torque 49 ± 5 N•m.
3. Tighten the bolt 3 shown in the illustration to the air control
valve at the specified torque 24 ± 3 N•m.
4. Tighten the bolt 4 shown in the illustration to the cam
position sensor support at the specified toque 11 ± 1
1
N•m.
5. Tighten the bolt 5 shown in the illustration to the exhaust
manifold at the specified torque 14 ± 1 N•m.
SENSOR INSTALLATION
11B-29