Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 626

Switch position p
OFF
Windshield wiper mist switch ON
Windshield intermittent wiper switch ON
Windshield low-speed wiper switch ON
Windshield high-speed wiper switch ON
Windshield washer switch ON
EXTERIOR -
Windshield Wiper and Washer
WINDSHIELD WIPER AND WINDSHIELD WASHER
SWITCH AND WINDSHIELD INTERMITTENT WIPER
INTERVAL ADJUSTING KNOB CHECK
<L.H.drive vehicles>
(1) Windshield wiper and washer switch, rear wiper and
Terminal No.
6 6
(2) Windshield intermittent wiper interval adjusting knob
WINDSHIELD INTERMITTENT WIPER INTERVAL
ADJUSTING KNOB CHECK
<R.H.drive vehicles>
Measure the resistance value at terminal numbers 4 and
6. The resistance value should rise smoothly from
approximately 0 W ("FAST" position) to approximately 1 kW
("SLOW" position).
NOTE
The windshield washer switch and windshield wiper switch
is integrated in the column-ECU, so can not be checked as
an individual part. However, its operation can be checked
by the input signal check. (GROUP 54B - Troubleshooting.)
washer switch.
7 7 8 8
Measure the resistance value at terminal numbers 3 and
6. The resistance value should rise smoothly from
approximately 0 Ω ("FAST" position) to apporoximately
1 kΩ ("SLOW" position).
9 9 10 10 11 11
51-19