Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 797

33A-14
MB991406,
MB990635 or
MB991113
Nut
Ball joint
Wooden block
Outside of
vehicle
Bushing
FRONT SUSPENSION -
REMOVAL SERVICE POINTS
AA" TIE ROD END AND KNUCKLE DISCONNECTION
Caution
1. To prevent the ball joint thread from damage, the tie
Cord
2. Support the special tool with a cord to prevent it from
AB" FIXTURE/BUSHING/STABILIZER BAR REMOVAL
Carry out the following operations to ensure working space
in order to remove the fixture, the bushing and the stabilizer
bar.
1. Use a transmission jack to hold the crossmember, and
2. Lower the crossmember until the fixture, the bushing and
Transmission jack
INSTALLATION SERVICE POINT
"AA STABILIZER BAR/BUSHING/FIXTURE
Identification colour
Align the stabilizer bar identification mark with the right end
of the bushing.
Fixture
Stabilizer Bar
rod end mounting nut must be only loosened but not
removed from the ball joint. Be sure to use the special
tool.
coming off.
then remove the crossmember mounting nuts and bolts.
the stabilizer bar can be removed.
Caution
Be careful not to lower the crossmember excessively,
otherwise the power steering return hose bracket may
deform.
INSTALLATION