Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 611

51-4
A
A
Double-sided tape: Generic products: 10mm width, 1.2mm thickness
Rivet
Front
bumper
face Drill
EXTERIOR -
Front Bumper
Front air dam
DISASSEMBLY SERVICE POINTS
AA" RIVET REMOVAL
Use the drill (ø4.0 mm) to make a hole in the rivet for removal.
AB" FRONT AIR DAM REMOVAL
The same procedures are applied as that of the removal
of side air dam. (Refer to P.51-10.)
REASSEMBLY SERVICE POINTS
"AA FRONT AIR DAM INSTALLATION
The same procedures are applied as that of the installation
of side air dam. (Refer to P.51-10.)
Section A – A
Front bumper face
Front bumper
lower plate
Front air dam