Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 1328

MD998781
Oil Seal
MB990938
MD998776
Oil Seal
Crankshaft
MD998285
MD998382
(oil applied to the
circumference)
Engine Front
Crankshaft
Degrease
Crankshaft
sprocket B
ENGINE -
Crankshaft Oil Seal
REMOVAL SERVICE POINT
AA" FLYWHEEL BOLT REMOVAL
INSTALLATION SERVICE POINTS
"AA CRANKSHAFT REAR OIL SEAL INSTALLATION
Crankshaft
1. Apply small quantity of engine oil on the circumference
2. Use special tool to press in oil seal up to the chamfered
"BA FLYWHEEL BOLT INSTALLATION
Use the special tool to fix the flywheel and tighten the bolt
to the specified torque in the same way as that for removal.
Tightening Torque: 132 ± 5 N·m
"CA CRANKSHAFT FRONT OIL SEAL INSTALLATION
1. Apply small quantity of engine oil on the circumference
2. Use special tool to press in oil seal up to the chamfered
"DA CRANKSHAFT SPROCKET B INSTALLATION
1. Clean and degrease crankshaft sprocket B and crankshaft
2. Position crankshaft sprocket B to the direction as shown
of oil seal lip.
surface of oil seal case.
of oil seal lip.
surface of oil seal case.
sprocket B mounting surface of crankshaft.
NOTE
Degrease to prevent the friction coefficient of pressed
surface from dropping by stuck oil.
in the illustration.
11A-27