Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 1385

11B-36
ENGINE OVERHAUL -
MD998713
Vane (small)
Cam position
sensor
3. Apply sealant on the contact surfaces with the head shown
in the illustration.
Sealant
4. Install the bearing caps onto the cylinder head, and in
two to three steps tighten strongly.
5. Finally, tighten at the specified torque 20 ± 1 N•m.
6. Confirm that the rocker arm is correctly installed.
NOTE
Wipe off all excessive sealant.
"DA CAMSHAFT OIL SEAL INSTALLATION
Install the oil seal using the special tool.
"EA CAM POSITION SENSOR SUPPORT
Apply a 3 mm width of form-in-place gasket at the position
shown in the illustration.
Form-in-place gasket
Specified gasket:
"FA CAM POSITION SENSING CYLINDER
1. Set the exhaust camshaft at the No. 1 compression top
dead centre.
NOTE
The shaft will rotate slightly in the counterclockwise
direction by the force of the exhaust valve spring.
2. Install the cam position sensing cylinder's vane (small)
Vane (large)
and vane (large) at the positions shown in the illustration.
Rocker Arm and Camshaft
Specified sealant:
TM
3M AAD Part No. 8672 or equivalent
INSTALLATION
Mitsubishi Genuine Part No. MD970389 or
equivalent
INSTALLATION