Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 731

35A-12
Front
Pads
Pads
MB990520
BASIC BRAKE SYSTEM -
<Brembo disc brake>
Caution
Take care not to contact the parts or tools to the caliper
because the paint of caliper will be scratched. And if
there is brake fluid on the caliper, wipe out quickly.
NOTE
The wear indicator contacts the brake disc when the brake
pad thickness reaches approximately 2 mm and emit a
squealing sound to warn the driver.
1. Check the brake pad thickness through the caliper body
Rear
2. When the thickness is less than the limit, always replace
On-vehicle Service
check port.
Standard value: 10.0 mm <Front>, 9.0 mm <Rear>
Limit: 2.0 mm
the pads at an axle set.
(1) Holding the cross spring with one hand, pull the pin
out of the caliper.
(2) Remove the pad from the caliper.
(3) To measure brake drag force after new pads have
been installed, use a spring balance to measure the
turning sliding resistance of the hub with the pads
removed. (Refer to P.35A-21.)
(4) Clean the piston and, using the special tool, push
the piston into the cylinder.