Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 1376

ENGINE OVERHAUL -
Protrusion
Fuel System
INSTALLATION SERVICE POINTS
"AA INJECTOR INSTALLATION
1. Apply a small amount of new engine oil on the O-ring.
2. While rotating the injector to the left and right, insert the
O-ring into the delivery pipe while taking care not to
damage it.
Caution
Make sure that the engine oil does not enter the
delivery pipe.
3. Confirm that the injector rotates smoothly. If it does not
rotate smoothly, the O-ring may be biting in. Remove
the injector, check the O-ring for damage, and then insert
it into the delivery pipe. Check the rotation again.
"BA FUEL PRESSURE REGULATOR INSTALLATION
1. Apply a small amount of new engine oil on the O-ring.
2. While rotating the fuel pressure regulator to the left and
right, insert the O-ring into the delivery pipe while taking
care not to damage it.
Caution
Make sure that the engine oil does not enter the
delivery pipe.
3. Confirm that the fuel pressure regulator rotates smoothly.
If it does not rotate smoothly, the O-ring may be biting
in. Remove the fuel pressure regulator, check the O-ring
for damage, and then insert it into the delivery pipe. Check
the rotation again.
"CA THROTTLE BODY GASKET INSTALLATION
Assembly so that the protrusion on the throttle body gasket
is at the position shown in the illustration.
11B-27