Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 1006

MANUAL TRANSMISSION OVERHAUL -
Lock pin
Control
housing
Type
stamp
side
2 mm
DISASSEMBLY SERVICE POINT
AA" LOCK PIN REMOVAL
Tap out the lock pin from the direction shown in the illustration.
Control
finger
REASSEMBLY SERVICE POINTS
"AA NEEDLE BEARING INSTALLATION
Press the needle bearing into the dimensions shown in the
Needle
illustration so that the type stamp side faces the indicated
bearing
direction.
"BA OIL SEAL INSTALLATION
Apply transmission oil on the oil seal lip section.
Transmission oil
Specified oil:
"CA AIR BREATHER INSTALLATION
(1) Apply sealant on the periphery of the insertion section.
Sealant
(2) Install so that the protrusion faces the direction shown
in the illustration.
Control Housing
MITSUBISHI genuine "DIA-QUEEN" multi gear oil
<75W/85W> or equivalent
Specified sealant:
3M SUPER WEATHERSTRIP
equivalent
22B-41
No.8001 or