Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 591

52B-60
Paint Marking
SRS check harness
(MB991613)
1
A
2
View A
3
Case
Protective tubes
2
3
Clock spring
2
3
SRS - Air Bag Modules and Clock Spring
4. Align the paint mark on the connector No.1 of the SRS
5. Check that there is continuity between the terminals 22
Clock spring
connector 3
<RS-II>
1. Check the connectors and protective tubes for damage,
2. Visually check the case for damage.
1
3. Refer to that the clock spring has continuity between
3
4. Insert the probe (MB991222) from the rear of connector
5. Connect a digital multi-meter to the probe (MB991222),
Probe
(MB991222)
Digital
multi-meter
check harness (MB991606 or MB991613) with the mark
indicated by an arrow on the connector No.3 of the clock
spring for connector connection.
and 23 of the SRS check harness connector No.2.
and terminals for deformation.
connector No.2 and terminal No.4 of connector No.1.
No.3 of the clock spring.
Caution
The probe must not be inserted directly to the
terminals from the front of the connector.
as shown, to check that conductivity is present between
the terminals.