Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 675

42-42
Grease application area
Trunk lid torsion bar
Tire lever
Trunk lid torsion bar (Left side)
Trunk lid torsion bar
(Right side)
Trunk lid hinge (Left side)
Trunk lid torsion bar
A
(Left side)
B
H
F
G
E
Trunk lid torsion
bar
C
Tire lever
BODY -
6
REMOVAL SERVICE POINT
AA" TRUNK LID TORSION BAR REMOVAL
Insert the tire lever into the torsion bar, and then pull upward
the tire lever to remove the torsion bar as shown in the
illustration.
NOTE
As the left and right trunk lid torsion bars are crossed at
the center, first remove the front trunk lid torsion bar at
the center.
INSTALLATION SERVICE POINTS
"AA TRUNK LID TORSION BAR INSTALLATION
Install the trunk lid torsion bar by the following procedure.
1. Ensure that there is the identification color at the center
Identification
color
C
D
2. Install the trunk lid torsion bar (Left side) as follows.
Trunk lid hinge
(Right side)
3. Install the trunk lid torsion bar (Right side) in the same
D
Trunk lid
7
of the trunk lid torsion bar.
Trunk lid torsion bar
Left side
Right side
Caution
As the trunk lid torsion bar (Right side) is painted
with differentiation color in the middle to differentiate
between RH and LH, be careful when installing.
(1) For terminal A, insert the trunk lid hinge (Left side)
into the fixed hole B
(2) For terminal C, touch the trunk lid hinge (Right side)
against portion E.
(3) For terminal D, insert the trunk lid hinge (Right side)
into portion F until portion G while twisting with the
tool such as a tire lever, etc.
(4) For terminal C, set the trunk lid hinge (Right side)
at portion H while twisting with the tool such as a
tire lever etc.
way as above.
2
Identification color
-
Red