Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 906

Rubber packing
Socket wrench
Bolt
LJ boot
Boot band Installation position
Projection
Boot
PROPELLER SHAFT - Propeller Shaft
4. Apply a little specific sealant to the surface which has
groove (for packing) of LJ assembly (allow as shown
in the illustration), fix the rubber packing.
Specified sealant: 3M Stud Locking 4170 or equivalent
5. Install the surface which has groove (for packing) of LJ
assembly to LJ boot side.
LJ assembly
6. Aline the mating marks of LJ assembly and center propeller
shaft, then punch the LJ assembly to center propeller shaft
using socket wrench.
7. Aline the position of bolt holes of LJ boot and LJ assembly,
install the LJ boot to LJ assembly.
8. Fix the rubber packing of companion flange side in a
similar to step 4.
"CA BOOT BAND INSTALLATION
Caution
1. Tighten the boot band part in opposite direction of
convex part for bleeding the boot.
2. If there is grease in the convex part, wipe out the
grease in order to bleed the boot.
25-9