Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 694

STEERING - Power Steering Gear Box and Linkage
<R.H. drive vehicles>
Removal steps
1. Crossmember
(Refer to GROUP 32.)
2. Joint cover grommet
3. Return hose connection
MB991006
15 ± 3 N·m
2
4
5
3
57 ± 7 N·m
1
INSPECTION
GEAR BOX PINION TOTAL ROTATION TORQUE CHECK
Caution
Secure the steering gear box and linkage in their mounting
positions only. Otherwise, deformation or damage could
result.
1. Using the special tool, turn the pinion gear at a speed
of one rotation per 4 to 6 seconds to measure total rotation
torque.
Standard values:
Total rotation torque: 0.8 – 1.8 N·m
Torque fluctuation: 0.49 N·m or less
NOTE
(1) Remove the bellows from the rack housing before
measuring.
(2) Measure the total rotation torque by turning the special
tool left and right 180_ from the neutral position.
2. If the standard values are not met, adjust the pinion total
rotation torque. (Refer to P.37A-26.)
3. In case the adjustment is impossible, disassemble and
check the components, and repair if necessary.
70 ± 10 N·m
6
7
4. Return tube
5. Pressure hose connection
6. Clamp
7. Steering gear and linkage
37A-17