Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 1323

11A-22
ø3 mm
Approximately 45_
Vane (small)
Vane (large)
ENGINE -
Camshaft and Camshaft Oil Seal
"FA CAMSHAFT POSITION SENSOR SUPPORT
1. Remove sealant remained on the camshaft position
2. Apply sealant to the flange of the camshaft position sensor
3. Tighten the camshaft position sensor support mounting
"GA CAMSHAFT POSITION SENSING CYLINDER
Dowel Pin
1. Set the dowel pin of the exhaust camshaft to the position
2. Install the vane (small) of the camshaft position sensing
3. Tighten the camshaft position sensing cylinder mounting
"HA RADIATOR UPPER HOSE CONNECTION
1. Insert the radiator upper hose to the convex part of the
2. Make the mating marks on the upper hose and the hose
"IA ROCKER COVER GASKET INSTALLATION
1. Remove sealant remained on the rocker cover.
2. Apply sealant to the positions (4 areas) of the lower side of
3. Install the rocker cover gasket to the rocker cover.
INSTALLATION
sensor support.
support and install to the cylinder head.
Specified sealant:
MITSUBISHI GENUINE PART MD970389 or
equivalent
bolt to the specified torque.
Tightening Torque: 14 ± 1 N·m
INSTALLATION
(No.1cylinder at compression TDC) as shown in the
illustration.
NOTE
Use the force of the exhaust valve spring to rotate
counterclockwise.
cylinder at an angle of approximately 45 degrees to the
position of the dowel pin of the exhaust camshaft.
bolt to the specified torque.
Tightening Torque: 22 ± 4 N·m
water outlet fitting.
clamp for installation.
the rocker cover as shown in the illustration.
Specified sealant:
MITSUBISHI GENUINE PART MD970389 or
equivalent