Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 448

(1) Headlamp centre
Screen line(low beam)
(3)
(2)
Vehicle centre line
(3)
10 m
In the centre of
headlamps (low beam)
(V)
Distance of
vertical direction
[120mm(0.69_)]
(H)
High intensity zone
CHASSIS ELECTRICAL -
4. If the fuel tank is not full, place a weight in luggage room
5. There should be no other load in the vehicle other than
6. Thoroughly clean headlamp lenses.
7. Place the vehicle on a level floor, perpendicular to a flat
8. Rock vehicle sideways to allow vehicle to assume its
9. Bounce the front suspension through three (3) oscillations
HEADLAMP ADJUSTMENT
<USING A SCREEN>
Low Beam Adjustment
1. Four lines of adhesive tape (or equivalent markings) are
2. Check if the low beam shining onto the screen is at the
Lamp centre
15_
Headlamp Assembly
of vehicle to simulate weight of a full tank 0.8 kg per litre.
driver or substituted weight of approximately 75 kg placed
in driver's position.
screen 10m away from the bulb center - marks on the
headlamp lens.
normal position.
by applying the body weight to hood or bumper.
required on screen or wall:
(1) Position a vertical tape or mark so that it is aligned
with the vehicle centre line.
(2) Measure the distance from the centre - marks on the
low beam headlamp lens to the floor. Transfer the
measurement to the screen. Horizontal tape or mark
on the screen is for reference of vertical adjustment.
(3) Measure the distance from the centre line of the
vehicle to the centre of each low beam headlamp.
Transfer the measurement to the screen. Vertical
tape or mark on the screen with reference to the
centre line of each low beam headlamp bulb.
standard value.
Standard value:
(Vertical direction)
120 mm (0.69_) below horizontal line (H)
(Horizontal direction)
Position at which the startup point of 15_ is
crossed with vertical line (V)
54A-25