Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 1078

Overrunning
Stop ring
clutch
Snap ring
Undercut
Segment
Mica
ENGINE ELECTRICAL -
REASSEMBLY SERVICE POINT
"AA STOP RING/SNAP RING INSTALLATION
Using a suitable pulling tool, pull overrunning clutch stop ring
over snap ring.
Stop ring
INSPECTION
COMMUTATOR CHECK
1. Place the armature in a pair of "V" blocks and check
the runout with a dial indicator.
Standard value: 0.05 mm
Limit: 0.1 mm
2. Measure the commutator outer diameter.
Standard value: 29.4 mm
Limit: 28.8 mm
3. Check the undercut depth between segments.
Standard value: 0.5 mm
Limit: 0.2 mm
BRUSH HOLDER CHECK
Confirm that the spring is activated when the brush is pressed
into the brush holder by hand.
Replace the brush holder if the spring is not activated.
Starting System
16-23