Radiator - Mitsubishi Electric Lancer Evolution-VII Workshop Manual

ENGINE COOLING -
Water pump or
thermostat case
O-ring
Warter inlet pipe

RADIATOR

REMOVAL AND INSTALLATION
Pre-remobal and Post-installation Operation
Engine Coolant Draining and Supplying (Refer to P.14-6.)
D
Under Cover Removal and Installation (Refer to GROUP 51 - Front Bumper.)
D
Air Cleaner Assembly Removal and Installation (Refer to GROUP 15.)
D
Air Hose E, Air Pipe C, Air hose D Removal and Installation (Refer to GROUP 15 - Intercooler.)
D
Battery and Battery Tray Removal and Installation
D
Water Hose and Water Pipe/Radiator
REMOVAL SERVICE POINT
AA" RADIATOR UPPER HOSE/RADIATOR LOWER
HOSE DISCONNECTION
After making mating marks on the hose and the hose clamp,
disconnect the hose.
INSTALLATION SERVICE POINTS
"AA O-RING INSTALLATION
Fit an O-ring into the groove of the water inlet pipe and
apply water to the circumference of the O-ring or the
inside of the mounting surface of the pipe for insertion.
CAUTION
Do not let the O-ring get contaminated with grease, such
as engine oil.
"BA WATER INLET PIPE INSTALLATION
After installing the water outlet fitting and the thermostat
case assembly, tighten the mounting bolt of the water
inlet pipe to the specified torque.
"CA RADIATOR LOWER HOSE/RADIATOR UPPER
HOSE CONNECTION
1. Insert each hose as far as the projection of the water
inlet pipe or water outlet fitting.
2. Align the mating marks on the radiator hose and hose
clamp, and then connect the radiator hose.
INSPECTION
WATER PIPE AND HOSE CHECK
Check the water pipe and hose for cracks, damage, clog
and replace them if necessary.
14-15