Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 794

Pillow ball bushing
Lower arm
assembly
MB991816
Marking
FRONT SUSPENSION -
LOWER ARM BALL JOINT DUST COVER
REPLACEMENT
MB990800
Only when the dust cover is damaged accidentally during
service work, replace the dust cover as follows:
Dust cover
1. Remove the dust cover.
2. Apply multipurpose grease to the lip and inside of the
3. Using the special tool, press the dust cover until it contacts
4. Press the dust cover with your finger to check that there
LOWER ARM PILLOW BALL BUSHING
REPLACEMENT
Replace the bushing as follows:
1. Use the special tools to drive out the bushing.
MB990651
MB991576
2. Set the bushing to the lower arm assembly in order to
60_
Lower Arm Assembly
dust cover.
the lower arm assembly.
are no cracks or damage in the dust cover.
the direction of bushing marking is upper, and of the
opening is the direction as shown in the illustration.
33A-11