Drive Shaft - Mitsubishi Electric Lancer Evolution-VII Workshop Manual

DRIVE SHAFT

REMOVAL AND INSTALLATION
Caution
1. If the vehicle is equipped with the Brembo disc brake, during maintenance, take care not to
contact the parts or tools to the caliper because the paint of caliper will be scratched. And
if there is brake fluid on the caliper, wipe out quickly.
2. With the part marked with *, first temporarily tighten it, then ground the vehicle and tighten
it to specification in unloaded condition.
Pre-removal Operation
Gear Oil Draining (Refer to P.27-17.)
D
Center Exhaust Pipe Removal (Refer to GROUP
D
15.)
54 ± 5 N·m
12
81 ± 6 N·m
5
Removal steps
1. Rear brake caliper
AA"
2. Rear brake disc
3. Parking brake shoe & lining assembly
(Refer to GROUP 36 - Parking Brake
Drum.)
4. Clip
5. Parking brake cable connection
6. Split pin
REAR AXLE -
25 ± 6 N·m
11
4
81 ± 6 N·m*
9
Drive Shaft
Post-installation Operation
Press dust cover with a finger to check for crack
D
or damage in the dust cover.
Center Exhaust Pipe Installation (Refer to GROUP
D
15.)
Gear Oil Filling (Refer to P.27-17.)
D
Parking Brake Lever Stroke Check and Adjustment
D
Wheel Alignment Check and Adjustment (Refer to
D
GROUP 34 – On-vehicle Service.)
8
10
88 ± 10 N·m*
AB" "BA 7. Drive shaft nut
8. Vehicle speed sensor<Vehicles with
ABS or ACD>
9. Knuckle and trailing arm connection
10. Knuckle and lower arm connection
11. Knuckle and toe-control arm connec-
tion
AC" "AA 12. Rear drive shaft assembly
27B-29
1
3
2
6
225 ± 25 N·m
7