Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 1067

16-12
Hole A
L-shaped
hexagon
wrench
ENGINE ELECTRICAL -
REMOVAL SERVICE POINTS
AA" DELIVERY PIPE, INJECTOR, AND FUEL
After loosening the installed parts, set the related parts
aside to make some space for removing the alternator.
AB" DRIVE BELT REMOVAL
Due to the adoption of the Serpentine drive system with
the auto-tensioner, the following operation is required:
1. Insert the 12.7sq. spinner handle into the tool hole of
the auto-tensioner and rotate it counterclockwise until
the auto-tensioner reaches to the stopper.
2. Align hole A with hole B for fixing by inserting the L-shaped
hexagon wrench, then remove the drive belt.
Caution
Hole B
When the drive belt is reused, use a chalk to
indicate an arrow of rotation direction on the
back of the belt so that it can be re-assembled in
the same direction as before.
AC"ALTERNATOR REMOVAL
Push up the engine with a garage jack to the top and
remove the alternator upward from the engine room.
Charging System
PRESSURE REGULATOR ASSEMBLY REMOVAL