Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 545

52B-14
<RS-II>
Dummy resistor
(MB991865)
resistance (3Ω)
Dummy resistor
(MB991865)
Resistor harness
resistance (3Ω)
(MB991866)
Clock spring harness
side connector C-204
Go to Next Page
SRS -
Resistor harness
(MB991866)
1
YES
YES
Troubleshooting
<Driver's seat air bag module (squib) check>
MUT-II self-diag code
D Disconnect the clock spring connector No.1 (connector connected with
the air bag module).
D Connect the dummy resistor (MB991865) to the resistor harness
(MB991866).
D Insert the resistor harness (MB991866) behind the clock spring
connector No.1.
Caution
Do not directly insert a probe or other devices at the front of the
connector to avoid a possible decrease in the contact pressure.
D Connect the negative (- ) terminal of the battery
D Check the diagnosis code again after erasing the memory.
Is code No.21 output?
Replace the driver's air bag module (squib).
<Clock spring check>
MUT-II self-diag code
D Release the clock spring connector (2- pin) C-204 .
D Connect the dummy resistor (MB991865) to the resistor harness.
D Insert the resistor harness
(MB991866) behind the harness side connector C-204 .
Caution
Do not directly insert a probe or other devices at the front of the
connector to avoid a possible decrease in the contact pressure.
D Connect the negative (- ) terminal of the battery
D Check the diagnosis code again after erasing the memory.
Is code No.21 output?
Replace the clock spring.
NO
NO