S518 (Ethernet Status Confirmation) - Hakko Electronics Monitouch V9 Series Connection Manual

1.5.2

$s518 (Ethernet Status Confirmation)

Stores the current status of the Ethernet.
Address
$s518
Error details
Built-in
No.
LAN
201
203
204
205
207
208
261
350
801
1202
2001
Contents
Ethernet status (for built-in LAN port)
Contents
Send error
TCP socket creation error
TCP connection over
TCP connection error
TCP send error
TCP connection interruption
notification from the connected
device
Send processing full error
Send buffer full
Link down error
MAC address error
Undefined error
1.5 System Device Memory for Communication Confirmation
 [0]: Normal
 [Other than 0]: Error
* For details on errors, refer to the next section.
Check that the setting on the target station is consistent with the network
table setting.
The TCP socket cannot be created. Turn the power off and back on again,
or check the communication line status, e.g., if the port number is
duplicated.
The number of connections reaches the maximum (256), and no more
connection is possible.
Check the communication lines.
Connection cannot be established.
Check the communication lines, or turn the power off and back on again.
TCP communication has failed.
Check the communication lines.
Check the connected device and communication lines.
Sending process is disabled. Check the communication lines.
The line is busy. Consult the network administrator of your company.
The communication unit is of an old version or is faulty.
Check the HUB or the link confirmation LED on the communication unit. If
the LED is not on, check cable connection and the port setting on the
network table.
The MAC address is not registered. Repair is necessary.
Turn the power off and back on again.
If the problem persists, the unit may be faulty. Contact your local
distributor.
Stored Value
Solution
1-63