Hakko Electronics Monitouch V9 Series Connection Manual page 296

16.2.8 FVR-E11S
Communication Setting
Editor
Communication setting
Item
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
Target Port No.
Inverter
Set communication parameters. Be sure to match the settings to those made under [Communication Setting] of the editor.
Function Code
H30
H31
H34
H35
H36
H37
-
*1 Available when the communication is enabled by digital input.
Example: To make the communication enabled when digital input terminal X1 is turned ON;
Set "18 (link operation)" for function code E01 and turn on the digital input terminal X1 externally.
Terminals from X2 to X5 can also be used. Set the function code corresponding to the digital input terminal to use.
*2 When "FVR-E11S" is selected for model selection on the editor, use "FGI-bus" for the communication protocol on the inverter.
Setting
1 : 1 / 1 : n / Multi-link2 /
Multi-link2 (Ethernet) /
1 : n Multi-link2 (Ethernet)
RS-422/485
4800 / 9600 / 19200 bps
7 / 8 bits
1 / 2 bits
None / Odd / Even
1 to 31
Item
*1
Link function
Station address
Baud rate
Data length
Parity bit
Stop bit
*2
Communication protocol
16.2 Temperature Controller/Servo/Inverter Connection
Setting
Monitor Frequency
0
1
2
3
1 to 31
0: 19200 bps
1: 9600 bps
2: 4800 bps
0: 8 bits
1: 7 bits
0: None
1: Even
2: Odd
0: 1 bits
1: 2 bits
"FGI-bus" is set as default.
(Underlined setting: default)
Remarks
(Underlined setting: default)
Example
Operation Command
16-43
3
1
1
0
0
0
-